Table of Contents
Advertisement
VB14N
Auto Learn
If you are configuring your scanner using the Mode Button, you must start with the Auto Learn
procedure.
1. Enter the Auto Learn function by holding the Mode push button pressed until the LEARN LED is
on.
2. Release the button to enter the Auto Learn function.
Once entered, the reader starts a procedure to automatically detect and recognize barcodes (by
type and length), which are presented to it (*). The laser turns on and the LEARN LED blinks to
indicate the ongoing process.
Figure 6 – Auto Learn Function
3. Exit the process by pressing the Mode push button once. The scanner will restart at the end of the
process, and then the detected barcodes are automatically configured in scanner memory.
If the barcode cannot be read because of low contrast or excessive ambient light,
you can perform the AutoSetup function to optimize the optical parameters. Then
you can perform AutoLearn to recognize the barcode symbology.
NOTE
On exit from Autolearn, the following parameters are forced: Code Combination =
Single Label, Reading Mode = Linear. If necessary, these parameters can be
changed through Genius™.
NOTE
* In case of Programming Barcodes (refer to the "ID-NET™: Programming Barcodes And Setup Procedure"
document).
6
The procedure is as follows:
A) place the desired barcode on the
scanline.
B) wait until the LEARN LED stays
steady on (indicating the reader
has detected the barcode).
C) repeat, if needed, the above two
steps to program up to 10 different
barcodes (the LEARN LED returns
to the blinking state for the next
code). If more than one barcode is
detected in the scan line, the Multi
Label mode is enabled (refer to the
"Software Configuration Parameter
Guide" Help file).
Advertisement
Table of Contents
