Vacuum/Pressure Pump Gauge Set; 90890-06756 Mityvac Brake Bleeding Tool Ys-42423 - Yamaha 2006 FJR1300AS Service Manual

b. Turn the main switch to "ON" and check that
the transmission is in neutral.
c. Add the recommended clutch fluid to the
proper level.
d. Install the clutch fluid reservoir diaphragm.
e. Connect the vacuum/pressure pump gauge
set "2" tightly to the bleed screw "3".
Vacuum/pressure pump gauge
set
90890-06756
Mityvac brake bleeding tool
YS-42423
2
f. Loosen the bleed screw.
g. Pump out the clutch fluid using the vacu-
um/pressure pump gauge set.
h. Tighten the bleed screw.
i. Disengage the clutch by turning the manual
clutch operation bolt "4" in direction "a" until it
stops.
j. Loosen the bleed screw and then retighten it.
k. Engage the clutch by turning the manual
clutch operation bolt in direction "b" until it
stops.
NOTE:
The following illustration shows the manual
clutch operation bolt when viewed from the rear
of the vehicle with the swingarm removed.
1
l. Repeat steps (i) to (k) until all of the air bub-
m. Tighten the bleed screw to specification.
n. Manually engage and disengage the clutch
o. Add the recommended clutch fluid to the
3
L LLL
3. Check:
• Pressure plate stroke
M MMM
a. Remove the pickup rotor cover bolts "1".
b. Remove the clutch cover "2".
2
c. Manually engage and disengage the clutch
NOTE:
Turn the clutch operation bolt in a continuous
motion, without allowing the pressure plate to
stop in mid-stroke.
– 32 –
bles have disappeared from the clutch fluid in
the plastic hose of the vacuum/pressure
pump gauge set.
Bleed screw
6 Nm (0.6 m·kg, 4.3 ft·lb)
30 times using the manual clutch operation
bolt.
proper level.
Refer to "CHECKING THE CLUTCH FLUID
LEVEL" on page 31.
L LLL L L LLL L L LLL L
M MMM M M MMM M M MMM M
Refer to "CLUTCH" in chapter 5. (Manual
No.: 3P6-28197-E0)
using the clutch operation bolt "3" five times,
each time for less than 1 second.
ENGINE
b a
4
L LLL L L LLL L LLL
M MMM M M MMM M MMM
1