Yamaha 2006 FJR1300AS Service Manual page 129

Fault code No. Sh_ _49
Order Item/components and probable
cause
1 Clutch operation.
2 Clutch slippage.
NOTE:
If the main switch is turned to "OFF", the fault code number will disappear from the display and will not
be displayed again when the main switch is turned back to "ON". Therefore, use the engine stop switch
to stop the engine, not the main switch. If the fault code number has disappeared, activate the diagnos-
tic mode and select diagnostic code No. Sh_ _61. The fault code numbers can be confirmed in the mal-
function history.
Fault code No. Sh_ _51
Order Item/components and probable
cause
1 Shift rod
2 Defective shift actuator sensor.
3 Confirm the operation of the main
switch after repairing the malfunction
or correcting the cause.
YCC-S (Yamaha Chip Controlled-Shift) SYSTEM
Symptom
Symptom
– 120 –
Engine idling speed is too high when vehicle is
started.
Check or maintenance job
• Check the clutch stroke.
Refer to "BLEEDING THE HY-
DRAULIC CLUTCH SYSTEM"
on page 31.
• Check the friction plate thick-
ness and replace the friction
plates if necessary.
Refer to "CHECKING THE
FRICTION PLATES" in chapter
5. (Manual No.: 3P6-28197-E0)
Shift actuator sensor signal is abnormal.
Check or maintenance job
• Check the shift rod pin hole lo-
cation.
• Check the shift rod groove loca-
tion.
• Adjust or replace the shift rod.
Refer to "CHECKING THE
SHIFT ROD" on page 59 and
"INSTALLING THE SHIFT AC-
TUATOR" on page 61.
• Replace the shift actuator.
• Execute the diagnostic mode.
(Code No. Sh_ _64)
Reinstatement
method
Turning the
main switch to
"OFF".
See NOTE.
Reinstatement
method
Repairing the
cause of the
malfunction.