Yamaha 2006 FJR1300AS Service Manual page 27

1. Rear wheel sensor lead
2. Rear brake fluid reservoir
3. Rear brake light switch lead
4. Clutch actuator motor lead
5. Clutch actuator sensor lead
6. Hydraulic unit
7. Brake hose (front brake master cylinder to
hydraulic unit)
8. Brake hose (hydraulic unit to proportioning valve)
9. Brake hose (hydraulic unit to metering valve)
10. Brake hose (hydraulic unit to front brake calipers)
11. Brake hose (rear brake master cylinder to
hydraulic unit)
12. Brake pipe (metering valve to right front brake
caliper)
13. Clutch hose
14. Rear brake light switch
15. Brake hose (proportioning valve to rear brake
caliper)
A. Route the rear wheel sensor lead to the inside of
the swingarm, making sure that the lead does not
protrude above the swingarm.
– –
B. 45 55 mm (1.77 2.17 in)
– –
C. 10 20 mm (0.39 0.79 in)
D. Route the rear brake light switch lead under the
rear wheel sensor lead.
E. Fasten the clutch actuator motor lead and clutch
actuator sensor lead to the brake hose (hydraulic
unit to front brake calipers) with the plastic locking
tie, making sure to face the end of the tie forward.
Do not cut off the excess end of the plastic locking
tie.
F. To clutch actuator
G. Fasten the rear wheel sensor lead to the brake
hose (proportioning valve to rear brake caliper)
with the two holders, making sure that the fastener
of each holder faces inward.
– 18 –
CABLE ROUTING