Starting Circuit Cut-Off System Operation - Yamaha 2006 FJR1300AS Service Manual

EAS27180

STARTING CIRCUIT CUT-OFF SYSTEM OPERATION

If the engine stop switch is set to "
switch circuit is closed), and the brake lever is squeezed (the front brake light switch circuit is open) or
the brake pedal is depressed (the rear brake light switch circuit is open), the starter motor can only op-
erate if at least one of the following conditions is met:
• The transmission is in neutral (the neutral switch is closed).
• The sidestand is up (the sidestand switch circuit is closed).
The starting circuit cut-off relay prevents the starter motor from operating when neither of these condi-
tions has been met. In this instance, the starting circuit cut-off relay stays open so current cannot reach
the starter motor. When at least one of the above conditions has been met, the starting circuit cut-off
relay is closed and the engine can be started by pushing the start switch " ".
a. WHEN THE TRANSMISSION IS IN
NEUTRAL
b. WHEN THE SIDESTAND IS UP
1. Battery
2. Main fuse
3. Main switch
4. Ignition fuse
5. Signaling system fuse
6. Engine stop switch
7. Starting circuit cut-off relay
8. Relay unit (diode)
" (the switch circuit is closed), the main switch is turned "ON" (the
19
18
1
2
3
5
4
7
6
12
8
8
8
10 9
a b
– 75 –
ELECTRIC STARTING SYSTEM
17
15
16
13
14
11
9. Sidestand switch
10. Neutral switch
11. Start switch
12. Front brake light switch
13. Brake light relay
14. Rear brake light switch
15. YCC-S control relay
16. MCU (motor control unit)
17. Diode 1
18. Starter relay
19. Starter motor