Shaft Drive; Installing The Drive Shaft And Final Drive Assembly; Fork Seal Driver Weight; Fork Seal Driver Attachment - Yamaha 2006 FJR1300AS Service Manual

EAS23550

SHAFT DRIVE

EAS23660
INSTALLING THE DRIVE SHAFT AND FINAL
DRIVE ASSEMBLY
1. Lubricate:
• Drive shaft spline (final drive pinion gear side)
Recommended lubricant
Molybdenum disulfide grease
2. Lubricate:
• Drive shaft spline (universal joint side)
Recommended lubricant
Lithium-soap-based grease
3. Install:
New
• Oil seal "1"
• Washer "2"
(with the fork seal driver weight "3" and fork
seal driver attachment "4")

Fork seal driver weight

90890-01184

Fork seal driver attachment

90890-01186
Replacement 27 mm
YM-A9409-1
4. Install:
• Circlip New
5. Install:
• Drive shaft "1"
(to the final drive pinion gear)
• Oil seal "2"
(to the final gear case with the fork seal driver
weight "3" and oil seal installing tool "4")
Fork seal driver weight
90890-01184

Oil seal installing tool

90890-01512
3
4
2
New
1
– 46 –
Installed depth "a"
8.5–10.0 mm (0.33–0.39 in)
3
6. Install:
• Universal joint
• Final drive assembly
NOTE:
Align the drive shaft splines with the driven yoke
of the universal joint.
7. Tighten:
• Final drive assembly nuts
Final gear case nut
42 Nm (4.2 m·kg, 30 ft·lb)
8. Install:
• Sidestand
• Left footrest assembly
Refer to "SHIFT ACTUATOR AND SHIFT
ROD" on page 57.
9. Install:
• Rear wheel
Refer to "REAR WHEEL" in chapter 4. (Man-
ual No.: 3P6-28197-E0)
10.Fill:
• Final gear case
Refer to "CHECKING THE FINAL GEAR OIL
LEVEL" in chapter 3. (Manual No.: 3P6-
28197-E0)
SHAFT DRIVE
1
4
2
a