Adjusting The Gear Position Sensor - Yamaha 2006 FJR1300AS Service Manual

ET2D21005

ADJUSTING THE GEAR POSITION SENSOR

1. Check:
• Gear position sensor
Refer to "CHECKING THE GEAR POSITION
SENSOR" on page 132.
2. Adjust:
• Gear position sensor angle
M MMM M MMM M M MMM M
a. Connect the gear position sensor coupler to
the gear position sensor.
b. Connect the digital circuit tester to the gear
position sensor.
• Positive tester probe →
yellow "1"
• Negative tester probe →
black/blue "2"
Digital circuit tester
90890-03174
Model 88 Multimeter with ta-
chometer
YU-A1927
c. Turn the main switch to "ON".
d. Measure the gear position sensor voltage.
e. Adjust the gear position sensor angle so that
the voltage is within the specified range.
Output voltage (at neutral posi-
tion)
0.71–0.91 V
f. After adjusting the gear position sensor an-
gle, tighten the gear position sensor screws
"3" to specification.
Gear position sensor screw
4 Nm (0.4 m·kg, 2.9 ft·lb)
LOCTITE
1
L LLL L LLL L L LLL L
M MMM M M MMM M M MMM M
®
3
2
L LLL L L LLL L L LLL L
3. Check:
• Gear position setting
Refer to "Diagnostic code table (Diagnostic
code No. Sh_ _65)".
MMM
LLL
– 50 –
ENGINE REMOVAL