Omron SYSDRIVE 3G3MV User Manual page 77

Preparing for Operation and Monitoring
Note 1. Local or remote selection is possible only when the Inverter is not in operation.
The present setting can be monitored when the Inverter is in operation.
Note 2. Local or remote settings in multi-function input terminals can be changed
through the multi-function input terminals only.
Note 3. Any RUN command input will be ignored while the LO/RE indicator is lit. To en-
able a RUN command, first turn OFF the RUN command and then press the
Mode Key to display an item with the green indicator (FREF to MNTR). Finally,
input the RUN command again.
H Example of Parameter Settings
Key Indicator
sequence
In
approximately
1 s.
Note 1. To cancel the set value, press the Mode Key instead. The parameter number
will be displayed.
Note 2. There are parameters that cannot be changed while the Inverter is in operation.
Refer to the list of parameters. When attempting to change such parameters,
the data display will not change by pressing the Increment or Decrement Key.
Cancels set
data.
In approximately 1 s.
Display
example
Power On
Press the Mode Key repeatedly until the
PRGM indicator is lit.
Use the Increment or Decrement Key to set
the parameter number.
Press the Enter Key.
The data of the selected parameter number
will be displayed.
Use the Increment or Decrement Key to set
the data. At that time the display will flash.
Press the Enter Key so that the set value will
be entered and the data display will be lit.
(see note 1)
The parameter number will be displayed.
Chapter 3
Explanation
3-9