Omron SYSDRIVE 3G3MV User Manual page 75

Preparing for Operation and Monitoring
Item Display
U-07 U-07 Output terminal Output terminal
status status
U-08 Torque monitor
U-09 U-09 Error log (most Error log (most
recent one) recent one)
U-10 Software No.
U-11 Output power
U-13 Accumulated
operating time
U-15 Communications
error
U-16 PID feedback
U-17 PID input
U-18 PID output
Display
unit
--- --- Shows the ON/OFF status of outputs.
Not
used
% Displays the torque being currently output as a
percentage of the rated motor torque. This display
can only be made in vector control mode.
--- --- The four most recent errors can be checked.
Error
generation
item
Note "1" means that the latest error is displayed.
Press the Increment Key to display the second
latest error. A maximum of four errors can be
displayed.
--- OMRON use only.
W Monitors the output power of the Inverter (see note
2).
x10H Monitor the accumulated operating time in 10-hour units.
(See note 3.)
--- Displays communications errors that occur during serial
communications (RS-422/RS-485). The errors that are
displayed have the same content as the serial
communications error at register number 003D Hex.
(Not used.)
% Monitors the PID control feedback (Max. frequency:
100%)
% Monitors the PID control input (Max. frequency:
100%)
% Monitors the PID output (Max. frequency: 100%)
Function
: ON : OFF
Terminal MA-MC: Multi-function contact output
Terminal P1-PC: Multi-function photo-coupler
output 1
Terminal P2-PC: Multi-function photo-coupler
output 2
Error
: Error
CRC error
Data length error
(Not used.)
Parity error
Overrun error
Framing error
Communications time-over
Chapter 3
: Normal
operation
3-7