Omron SYSDRIVE 3G3MV User Manual page 188

Advanced Operation
Set Values
Select the operation status to be accumulated
·
Value
0 Accumulate the Inverter's power-ON time (the time from when the power is
turned ON until it is shut OFF).
1 Accumulate the Inverter's RUN time (the time that the RUN command is
being input).
Accumulated Operating
n088
Time Selection
Setting 0 to 6,550
range
Set the initial value for the accumulated operating time with 10 hours set as 1. The ac-
·
cumulation will begin from the time that is set.
To clear (i.e., set to 0) the monitor value (U--13) for the accumulated operating time,
Note
set n088 to 0. The monitor value cannot be cleared by setting n001 (parameter
write-prohibit selection/parameter initialization) to 8 or 9 (initialize).
6-10-8 Frequency Detection Function
·The 3G3MV has the following frequency detection functions.
Frequency Detection:
Detects that the frequency reference coincides with the output frequency.
Frequency Detection Levels 1 and 2:
Detects that the output frequency is the same as or higher or lower than the set value
(frequency detection level) in n095.
·The multi-function outputs (n057 to n059) must be set for the frequency detection func-
tion.
6-46
.
Description
Register 0158
Hex
Unit of 10 H
setting
Chapter 6
Changes during No
operation
Default setting 0