Table of Contents
Advertisement
Maintenance Menu
The MAINTENANCE MENU also enables you to display the configuration of the system in a
non-cryptic, easily understandable way, to perform various tests, to continue IPL either from
network, a specific SCSI device or from the boot list, and to set flags concerning various
system operation.
The MAINTENANCE MENU can only be entered by:
1. Enabling the BUMP Console from the STAND-BY MENU.
2. Setting the Autoservice IPL flag to disabled (the default value for this flag is disabled)
from the STAND-BY MENU.
3. Having a Valid Service Contract.
4. Turning the System Key to the Service position.
5. Powering-on the system.
The MAINTENANCE MENU shown below should appear just after the 292 code is
displayed on both the console and the LCD.
For Details,
See the
Following
Pages
2-22
2-25
2-25
2-25
2-25
2-25
2-26
2-28
2-32
2-38
MAINTENANCE MENU (Rev. XX)
0> DISPLAY CONFIGURATION
1> DISPLAY BUMP ERROR LOG
2> ENABLE SERVICE CONSOLE
3> DISABLE SERVICE CONSOLE
4> RESET
5> POWER OFF
6> SYSTEM BOOT
7> OFF–LINE TESTS
8> SET PARAMETERS
9> SET NATIONAL LANGUAGE
SELECT:
2-21
Using SystemGuard
Advertisement
Table of Contents
