Base Unit Adapters - IBM 7012 G Series Service Manual

Base Unit Adapters

Note: Refer to "Handling Static-Sensitive Devices" on page 4-2 before removing or
installing adapters in this system.
Removal
1. Remove the front cover following the procedures on page 4-3.
2. Remove the side cover following the procedures on page 4-6.
3. Remove the rear cover following the procedure on page 4-8.
4. Facing the rear of the system unit, place it in horizontal position with the right side down.
5. Record the location and type of the adapter.
6. Disconnect any attached devices and internal cables from the adapter.
Attention: Be careful in handling the adapter: use the adapter pullers and do not touch
the adapter components. It is strongly recommended that you keep the adapter in the
antistatic envelope until you are ready to insert it in the required slot, to protect it against
electrostatic discharge.
7. Loosen the retaining screw which locks the adapter on the rear side of the system unit.
4-14
Service Guide
Retaining Screw