Table of Contents
Advertisement
Display Configuration
Use this option to view the system hardware configuration. This option provides different
screens with the following levels of information:
System-level information
Unit-level information
Device-level information.
Enter 0 in the MAINTENANCE MENU to select the Display Configuration option.
Display Configuration – System Level
This screen displays general system information, such as:
Firmware release number.
Machine ID.
Service Contract status.
Total memory size, and other information.
MACHINE TYPE/MODEL: 7013/J30
FIRMWARE RELEASE:
SERVICE CONTRACT:
AUTO DIAL:
CONSOLES:
SYSTEM ID:
NUMBER OF CPU:
MAIN MEMORY SIZE:
PRESENT UNITS:
SELECT [Unit# (0–7) or x:exit]:
To view information for a specific unit, enter a unit number. A unit level screen is displayed,
as described on the following pages.
Note: If and expansion unit is not attached, the SELECT [Unit# (0–7) or x:exit]
option does not appear, press Enter to continue to the next screen.
Display Configuration – Unit Level
This is the second screen in the configuration group. When selected, you see two different
types of screens:
Main Unit
Expansion Unit.
The main unit screen, shown below, displays unit level parameters such as:
2-22
Service Guide
DISPLAY CONFIGURATION
Standby –> 1300
Backup eprom –> 0401
Flash eprom –> 0401
Last update (yymmdd) –> 941105
Validity–> 360 Days
Remote service support –> Valid
Quick On Call service –> Not valid
Disable
BUMP Console –> Present
Service Console –> Disable – 1200 Baud
000ABCDE (Contains the serial
number of the unit)
2
128 MByte
#0 ,#1
Advertisement
Table of Contents
