System Unit Base - IBM 7012 G Series Service Manual

System Unit Base

Removal
1. Set the power switches on the attached devices to Off.
2. Set the power switch on the system unit to Off.
3. Unplug the power cable from the wall outlet.
4. Put the system unit in horizontal position.
5. Loosen the retaining screws used to lock the base to the unit.
6. Remove the base from the unit.
Replacement
1. Align the base with the system unit frame.
– If you are installing the base on the base system unit, install it with its lateral tongues
towards the rear of the unit.
2. Secure the base to the system unit by tightening the retaining screws.
3. Plug in the power cable.
4. Set the power switch on the system unit to On.
5. Set the power switches on the attached devices to On.
4-10
Service Guide