Inside Wire Feeder Unit; Assembly Of Kempoweld Equipment - Kemppi Kempoweld WIRE 400 Operating Manual

3.4

inside wire Feeder unit

K4 Wire inch switch (wire feed into gun)
R3 Burn back time adjustment (according to filler material and wire feed)
04 Locking device for wire reel
05 Box door latch
06 Box door lock
07 Wire feed mechanism
4.

assemBlY OF KempOweld eQuipment

Kempoweld power source: Read the paragraph INSTALLATION in the operation instructions for
the power source.
wire feeder:
1. Mount the wire feeder unit into pin on the power source´s cover. When necessary you
can lock the wire feeder to the support piece on the power source´s cover.
2. Mount the control cable and welding current cable to connectors on the rear walls and
the return current cable to the connector on Kempoweld´s front panel.
3. Welding current polarity: By the connection made according to markings, the gun has
positive voltage. In order to change the polarity interchange the welding and return
current cable ends connected to the power source with each other.
4. If the MIG gun is water-cooled, mount the water hoses to the wire feeder unit.
5. Mount the interconnection cable to the same connections.
The hoses of the water-cooled interconnection cable go also through the wire feeder unit.
NOTE!
6. The wire feeder must be mounted to boom without galvanic contact to lift hook and
boom. See the paragraph ACCESSORIES.
7. The MIG gun is mounted to the EURO connector. Use guide tubes and contact tips
according to manufacturer´s operation instructions. Accessories which are too narrow
or otherwise unsuitable for the wire type used by you, will cause disturbances and
excessive wear for accessories.
EN
9