Rear Section - JVC GY-HD200U Instructions Manual

CONTROLS, INDICATORS AND CONNECTORS

Rear Section

3
4
1Back tally lamp
This lamp lights up when this device enters the record
mode. It blinks during the transition to the record mode.
When the tape has run out, or the VTR enters the warning
mode, it blinks quickly.
• Use the BACK TALLY item on the OTHERS[1/2] menu
screen to select whether or not the lamp should light
and the lighting pattern.
X See page 93.
2[PHONES] Earphone jack
This is a stereo mini-jack for connecting an earphone for
audio monitoring. Plug in an earphone or headphone with
a 3.5 mm diameter plug. The earphone can also be used
to monitor alarm tones in accordance with the circum-
stances.
The audio channel to be output is selected with the AUDIO
MONITOR item on the AUDIO/MIC[2/2] menu screen and
MONITOR SELECT switch d on page 19.
The audio output level is adjusted with the Audio monitor
volume control 3 on page 14.
MEMO
• The volume of the alarm sound is set with the ALARM
VR LEVEL item on the OTHERS[1/2] menu screen.
• When using a stereotype jack and stereo sound should
be output, the following setting should be performed.
Set the MONITOR SELECT switch d on page 19 to
BOTH.
Set the AUDIO MONITOR item on the AUDIO/MIC[2/2]
menu screen to STEREO.
12
Connecting the Earphone Cable
To reduce the emission of unwanted radio waves, be sure to
attach the provided clamp filter as shown in the figure below.
• Attach the clamp filter as close to this device as possible,
as shown in the figure.
1
2
3Shoulder belt hooks
Allows you to attach a separately sold shoulder belt.
4LCD monitor
Shows a color camera image or the VTR playback picture.
It is also used for displaying the following:
• Menu Setting screens
• Characters showing the whether this device is set to
shooting mode or VTR playback mode
• Date and time and time code
• Audio level meter
• Warning indications, etc.
X See page 22.
Earphone cable
Clamp filter