Automatic Sheet Feed - OKIDATA ML320 Turbo Service Manual

2.2.7 Automatic Sheet Feed

This function is used to feed in the sheet automatically up to the print start position when the cut sheet or
the continuous sheet paper is used.
Operational procedure
(1) When using cut sheet paper:
1) Set the change lever to the TOP position. (See Figure 2-17 below).
2) Insert a sheet of paper between the platen and the paper chute.
3) After the lapse of time selected by the "wait time" item in the menu, the LF motor starts to feed
the paper up to the print position.
4) When the default is selected, the paper feeds up to the position 0.35 inches (first dot position)
from the top edge of the sheet. However, the 0 tear-off mechanism allows printing at the top edge
of the sheet by changing the TOF position.
(2) When using continuos sheet paper
Service Guide ML320/321Turbo
Chapter 2 Operation Description
Page: 19