Second Paper Feed Unit - OKIDATA OL830 Service Manual

3.2.06 Second Paper Feed Unit

The Second Paper Feed Unit doubles the OL830s paper handling capacity by adding a second
paper feed mechanism. The paper tray is sold separately. Here are the procedures for adding the
Second Paper Feed Unit to the printer. Reverse these procedures for removal.
Before installation/removal, perform this procedure.
1. Set power switch to OFF and unplug the power cord.
2. Remove the interface cable, paper tray, and font cards, if installed.
3. Remove the image drum and toner cartridge. Put them in a safe place where the image
It is not necessary to turn the printer upside down. The printer is shown upside down for
illustration only.
drum will not be scratched or exposed to light.
1. Remove the connector cover from the bottom of the printer using a flat
blade screwdriver. This will expose an edge connector. Do not discard
the connector cover. It must be installed if the Second Paper Feed Unit is
removed from the printer.
2. Unpack the Second Paper Feed Unit. Notice the two metal guide pins
and the black connector. The two metal guide pins are used for
alignment. The edge connector, on the bottom of the printer, will attach to
the black connector.
Service Guide OL830
Chapter 3 Maintenance & Disassembly
Page: 45