Rear Tractor Assy - OKIDATA ML320 Turbo Service Manual

Page: 44
Service Guide ML320/321Turbo
Chapter 3 Parts Replacement

3.3.20 Rear Tractor Assy

(see 3.3.1 ).
(1) Remove the printhead
(see 3.3.2 ).
(2) Remove the ribbon protector
(see 3.3.3 )
(3) Remove the pull-up roller assy
(see 3.3.4
(4) Remove the upper cover ).
(5) Remove the reset spring (see 3.3.17 (3) ).
(6) Remove the tractor gear 1.
(7) Shift the drive shaft 2 to the right side to remove (in the direction of the arrow).
(8) To install, reverse the removal procedure.
Note on installation:
When the tractor assemblies (L) 3 (R) 4 have been detached from the drive shaft, align the protrusions 5
of the pin tractor wheels in the same direction as before assembly.