Network Failure Detection; Figure 47: Network Failure Detection Screen - Quasar CM-4321 User And Installation Manual

File Name
The uploaded image's filename format is set in this section. Select one that meets your requirements.
Save
Click Save to save the motion detection settings.

7.3.9 Network Failure Detection

The network failure detection function allows the IP camera to periodically ping another IP device
within the network to detect a network failure, for example, if a video server is disconnected. By
implementing local recording (through a microSD/SDHC card) if a network failure occurs, the camera
can operate as a backup recording device for the surveillance system.
Detection Switch
The Administrator can enable or disable the detection function by selecting On or Off.
By Schedule
For instructions how to set a schedule for network failure detection, refer to Schedule.
Detection Type
In the text box, enter the IP address to ping and the time interval in minutes between pings.
Triggered Action
The Administrator can specify various alarm actions to be taken when an alarm is triggered. The
options are as follows:

Record stream to sd card -– Select this box in order to save the alarm-triggered recording into
a microSD/SDHC card. Enter the number of seconds for the pre-trigger buffer. Select the first
radial button to upload for a specified length of time and enter the number of seconds.

Figure 47: Network Failure Detection Screen

Configuration and Operation
43