Quasar CM-4321 User And Installation Manual page 98

CM-4321 User and Installation Guide
3. In the Device Search application, click the Device Search button.
4. If the Windows Firewall is enabled, a security alert window will pop up. Do the following:
a. Click Unblock to continue. Latitude users should consult the Latitude Installation
Instructions on disabling the Windows Firewall.
b) Click Device Search again. All the discovered IP devices will be listed in the page, as
shown in the figure below. The camera's default IP address is automatically set by the
DHCP server.
5. Right-click on the camera whose network property is to be changed. From the menu that
opens, select Network Setup. The Network Setup dialog is displayed.
6. To access Device Search, do one of the following:
a) For DHCP (not supported by Latitude):
i) Select DHCP. Do not use for Latitude.
ii) Click Apply. When prompted with instructions to search again after one minute,
click OK.
iii) After one minute, click Device Search.
b) For Static IP (recommended for Latitude users):
i) Select Static IP (preferable for security and Latitude users). In the IP Address,
Gateway, and Netmask, enter the respective LAN/VLAN (optional DNS) values.
ii) Click Apply. When prompted with instructions to search again after one minute,
click OK.
iii) After one minute, click Device Search. The communication settings should now be
changed and ready to install the camera on the network. Access it either via the
browser-based viewer or Latitude NVMS.
86
Figure 86: Windows Security Alert
Tip:
Record the camera's MAC address for future reference.