Tampering; Figure 48: Tampering Alarm Screen - Quasar CM-4321 User And Installation Manual

CM-4321 User and Installation Guide
Alternatively, select the second radial button to upload during the active trigger. See Figure
46: Record Stream to SD Card.
Note:
Make sure that local recording (with a microSD/SDHC card) is activated so that this
function can be implemented. See

Send message by FTP/E-Mail – Select whether to send an alarm message by FTP and/or e-mail
when a network failure is detected.
Save
Click Save to save the network failure detection settings.

7.3.10 Tampering

The Tampering Alarm function helps the IP camera deal with tampering (such as, deliberate
redirection, blocking, paint-spraying, and obscuring the lens, etc.). Using video analysis, the camera
can react to such events by sending out notifications or uploading snapshots to the specified
destination(s).
Detection of camera tampering is achieved by measuring the differences between the older frames of
video (which are stored in buffers) and more recent frames.
Tampering Alarm
The tampering alarm function may be turned on or off in the Tampering Alarm page. The default
setting is Off.
By Schedule
For instructions how to set a schedule for the tampering alarm, refer to Schedule.
44
Recording

Figure 48: Tampering Alarm Screen

for further details.