Figure 43: Upload Image By Ftp - Quasar CM-4321 User And Installation Manual

Detailed settings for motion detection are as follows:

Sampling pixel interval [1-10] – Select a number from 1-10. The default value is 1. If the value
is set as 3, within the detection region, the system will take one sampling pixel for every 3
pixels by each row and each column (see the figure below).

Detection level [1-100] – Select a number from 1-100. The default level is 40. This sets
detection level for each sampling pixel; the smaller the value, the more sensitive it is.

Sensitivity level [1-100] – Select a number from 1-100. The default level is 80, which means if
20% or more sampling pixels are detected differently, the system will detect motion. The
bigger the value, the more sensitive it is. When the value is bigger, the red horizontal line in
the motion indication window will be lowered accordingly.

Time interval (sec) [0-7200] – Select a number from 0-7200 (seconds). The default interval is
10. The value is the interval between each detected motion.
Triggered Action
The Administrator can specify alarm actions to be taken when motion is detected. The options are
listed as follows:

Send Alarm Message by FTP/E-Mail – Select whether to send an alarm message by FTP and/or
e-mail when motion is detected.

Upload Image by FTP – Select this box in order to upload an image to a designated FTP site
when motion is detected according to various parameters as shown in the figure below.

Upload Image by FTP – Select this box in order to upload an image to a designated FTP site
when motion is detected according to various parameters, as seen in Figure 43: Upload Image
by FTP. Specify the FTP address to use from the drop-down menu. Select the number of
frames for the pre-trigger and post-trigger buffers from the drop-down menu of 1-20 frames.
Check the box for Continue image upload if you wish to use this option. To specify the length
of time for the upload, click on this radial button and enter the number of seconds. To upload
during the active trigger, click on this radial button. Finally, select the number of frames per
second from the drop-down menu next to Image Frequency.
.

Figure 43: Upload Image by FTP

Configuration and Operation
41