Floppy Disk Connector: Fdd; Hard Disk Connectors: Ide1/Ide2; Fan Connectors: Fan1/Cpufan/Sysfan - Acorp 7KT400 User Manual

Chapter 1

1.7.3 Floppy Disk Connector: FDD

This connector supports the provided floppy drive ribbon
cable. After connecting the single end to the board, connect
the two plugs on the other end to the floppy drives.

1.7.4 Hard Disk Connectors: IDE1/IDE2

These connectors are provided with IDE hard disk ribbon
cable into the package . After connecting the end of cable
with single connector to the mainboard, connect the other
two connectors at the other end to your hard disk. If you
install two hard disks, you must configure the second drive
to Slave mode by setting its jumper settings. BIOS now
supports SCSI device or IDE CD-ROM boot up (see "HDD
Sequence SCSI/IDE First" & "Boot Sequence" in the BIOS
Features Setup of the BIOS SOFTWARE).

1.7.5 Fan Connectors: FAN1/CPUFAN/SYSFAN

CPUFAN1
Connector
BIOS
FAN1
Connector
VIA
KT400
VIA
VT8235
SYSFAN1
Connector
1-15
Motherboard 7KT400
CPU/SYSFAN Pin Definition
1 Sensor
1
2 +12VDC
2
3
3 Ground
FAN1 Pin Definition
1 Ground
1
2 +12VDC
2
3
3 Ground