Acorp 7KT400 User Manual page 54

Chapter 2
UART Mode Select
This item allows you to select which Infra Red(IR) function of
the onboard I/O chip you wish to use.
The Choices: Normal(default), IrDA, ASKIR.
RxD' TxD Active
This item allows you to select the high /Low status of the RxD,
TxD Active mode.
The Choices: Hi,Lo; Lo,Hi; Lo,Lo; Hi,Hi
IR Transmission delay
This item allows you to enable / disable the IR Transmission
Delay function.
The Choices: Enabled; Disabled
UR2 Duplex Mode
This item allows you to select which Infra Red(IR) function of
the onboard I/O chip you wish to use.
The Choices: Half (default), Full.
Use IR Pins
This item allows you to select the IR Pins.
The Choices: IR-Rx2Tx2; RxD2, TxD2
Onboard Parallel Port
This item allows you to select the Onboard Parallel Port .
The Choices: 378/IRQ7; 278/IRQ5; 3BC/IRQ7; Disabled
Parallel Port Mode
The choices are for Parallel Port Mode select:
SPP: Using Parallel port as Standard Parallel Port;
EPP: Using Parallel port as Enhanced Parallel Port;
ECP: Using Parallel port as ExtendedCapabilites Port;
ECP+EPP Using Parallel port as ECP+EPP mode;
Normal;
7KT400 BIOS Setup
2-54