Table of Contents
Advertisement
Chapter 1
1.7.3 Floppy Disk Connector: FDD
This connector supports the provided floppy drive ribbon
cable. After connecting the single end to the board, connect
the two plugs on the other end to the floppy drives.
1.7.4 Hard Disk Connectors: IDE1/IDE2
These connectors are provided with IDE hard disk ribbon
cable into the package . After connecting the end of cable
with single connector to the mainboard, connect the other
two connectors at the other end to your hard disk. If you
install two hard disks, you must configure the second drive
to Slave mode by setting its jumper settings. BIOS now
supports SCSI device or IDE CD-ROM boot up (see "HDD
Sequence SCSI/IDE First" & "Boot Sequence" in the BIOS
Features Setup of the BIOS SOFTWARE).
1.7.5 Fan Connectors: FAN1/2/3
FAN1
Connector
RTL8101L
AGP8X/4X
FAN1, FAN2 and FAN3 connectors
Socket 478
SiS
650GX
PCI1
SiS
962L
PCI2
Battery
PCI3
1-17
Motherboard 4S651M/4S651MN
Pin
1
1
2
2
3
3
FAN2
Connector
FAN 3
Connector
Definition
Ground
+12VDC
Signal
Advertisement
Table of Contents
