This chapter describes how to configure Spanning Tree Protocol (STP) and IronSpan parameters on Foundry
Layer 3 Switches using the CLI. IronSpan features extend the operation of standard STP, enabling you to fine tune
standard STP and avoid some of its limitations.
Chapter Contents
Description
Overview of STP
Configuring standard STP parameters
Per VLAN Spanning Tree (PVST)/PVST+ compatibility
December 2005
Configuring Spanning Tree Protocol (STP)
Table 7.1: Chapter Contents
Enabling and disabling STP
802.1W Draft 3 RSTP (both 802.1W Draft 3 and full
802.1W are supported)
Single-instance STP (SSTP)
STP per VLAN group
© Foundry Networks, Inc.
and IronSpan Features
See Page
7-2
7-2
7-2
7-4
7-5
7-6
7-8
7-16
7-16
7-18
7-53
7-56
7-58
7-61
Chapter 7
7 - 1