Foundry Configuration Guide for the FESX, FSX, and FWSX
Displaying OSPF Interface Information
To display OSPF interface information, enter the following command at any CLI level:
FastIron SuperX Router# show ip ospf interface 192.168.1.1
Ethernet 2/1,OSPF enabled
IP Address 192.168.1.1, Area 0
OSPF state ptr2ptr, Pri 1, Cost 1, Options 2, Type pt-2-pt Events 1
Timers(sec): Transit 1, Retrans 5, Hello 10, Dead 40
DR:
Router ID 0.0.0.0
BDR: Router ID 0.0.0.0
Neighbor Count = 0, Adjacent Neighbor Count= 1
Neighbor: 2.2.2.2
Authentication-Key:None
MD5 Authentication: Key None, Key-Id None, Auth-change-wait-time 300
Syntax: show ip ospf interface [<ip-addr>]
The <ip-addr> parameter displays the OSPF interface information for the specified IP address.
The following table defines the highlighted fields shown in the above example output of the show ip ospf
interface command.
This field
IP Address
OSPF state
Pri
Cost
Options
20 - 42
Table 20.4: Output of the show ip ospf interface command
Displays
The IP address of the interface.
ptr2ptr (point to point)
The link ID as defined in the router-LSA. This value can be one
of the following:
1 = point-to-point link
3 = point-to-point link with an assigned subnet
The configured output cost for the interface.
OSPF Options (Bit7 - Bit0):
•
unused:1
•
opaque:1
•
summary:1
•
dont_propagate:1
•
nssa:1
•
multicast:1
•
externals:1
•
tos:1
© Foundry Networks, Inc.
Interface Address 0.0.0.0
Interface Address 0.0.0.0
December 2005