1-Piece Surround Panel; Routing The Power Cord; Installation - Travis Industries 33 DVI GSB2 Owner's Manual

Installation (for qualified installers only)

1-Piece Surround Panel


DVL – 34" by 44"

DVL – 30-1/2" by 42"
NOTE: The panels may be cut down in size and placed within the fireplace opening.

Routing the Power Cord

Because this panel fits flush against the fireplace facing, the panel does not have a notch allowing the power
cord to exit the fireplace. We recommend using the insert wiring kit (sku 97200315) to route power to the
insert. Otherwise, route the power cord behind the panel to the right side (the panel or fireplace may be
notched, if required).

Installation

1. Attach the mounting brackets as shown below.
© Travis Industries
96100319
96100323
a. Remove the two screws from the air
b. Slide the upper mounting brackets into
c. Attach the lower mounting brackets with
d. Replace the two screws removed in step
e. Install two screws into the upper holes on
4140813
deflector.
place. NOTE: The brackets slide under
the air deflector. Secure the upper
brackets with the included screws.
two screws (use the lower holes).
"a".
the mounting brackets.
NOTE: The upper screws keep the
brackets from swiveling.
19
100-01297