Replacing The Reflector - PRG BAD Boy Field Service Manual

B B ™ S L
AD OY POT UMINAIRE

Replacing the Reflector

Parts:
42.9812.0160
Tools and Supplies:
#2 Phillips screwdriver, long or #2 Philips screwdriver, right-angle
Cotton gloves or finger cots
WARNING: Remove power from luminaire before performing any maintenance procedures.
CAUTION: Do not touch reflector with bare fingers. If dirty, clean with OptiMax™ Ultra Pure
Cleaning Solution and a Micro Fiber cloth.
To replace the Reflector:
Step 1. Remove power from luminaire and allow components to cool for at least 5 minutes.
Step 2. Remove Aft Cover. (Refer to
Step 3. At Reflector, loosen four 6-32 x 1/4" PPB screws to free mounting clips
Step 4. Remove Reflector by carefully sliding out from under XYZ Assembly. (Insulator will come
loose during removal. Do not lose Insulator.)
Step 5. Replace Reflector by doing steps in reverse.
6 4
F S M
IELD ERVICE ANUAL
1 EA REFLECTOR, 36 LUNES, COATED
XYZ Assembly
Reflector
6-32 x 1/4"
PPB Screw (4)
Mounting
Clip (4)
Figure 3-29: Removing Reflector
"Removing the Aft Cover"
Insulator
on page 28.)
(Figure 3-29).
Head Assy
02.9812.0005