Replacing The Diffuser Sensor Pcb - PRG BAD Boy Field Service Manual

Replacing the Diffuser Sensor PCB

Parts:
24.9812.0570
Tools and Supplies:
#2 Philips screwdriver
Small slotted screwdriver
WARNING: Remove power from luminaire before performing any maintenance procedures.
CAUTION: Always use anti-static precautions when working with PCBs.
To replace the Diffuser Sensor:
Step 1. Remove power from luminaire and allow components to cool for at least 5 minutes.
Step 2. Remove R1 Head Cover. (Refer to
Step 3. At Diffuser Sensor, disconnect cable
Step 4. Remove Diffuser Sensor by removing two 4-40 x 3/16" PFSS screws.
0 2. 9 8 1 2. 0 0 05
M
AINTENANCE
1 EA PCB ASSY, DIFFUSER SENSOR
: R
EMOVE AND
"Removing the Head Covers"
(Figure 3-22).
R P
EPLACE ROCEDURES
on page 26.)
3
53