Cleaning The Head Electrostatic Filters - PRG BAD Boy Field Service Manual

B B ™ S L
AD OY POT UMINAIRE

Cleaning the Head Electrostatic Filters

The electrostatic filters should be cleaned or replaced when they are dirty. The frequency will depend
on how often and in what conditions the luminaire is used.
Tools and Supplies:
#2 Phillips screwdriver
Compressed air and/or water
To clean head filters:
WARNING: Remove power from luminaire before performing any maintenance procedures.
Step 1. Remove power from luminaire.
Step 2. At each mesh cover, loosen one captive screw
Step 3. Remove foam and electrostatic filters.
Step 4. Clean foam and electrostatic filters with compressed air and/or by washing with water.
Step 5. Re-install components.
Step 6. Repeat for second set of filters.
3 0
F S M
IELD ERVICE ANUAL
Parts:
10.9812.0661
10.9812.0662
NOTE:
If the filters do not get clean after multiple
attempts, they should be replaced.
Figure 3-5: Removing Head Filters
2 EA HEAD AIR FILTER FOAM
2 EA HEAD AIR FILTER ELECTROSTATIC
(Figure 3-5).
Electrostatic Filter
Foam Filter
Captive Screw
Mesh Cover
02.9812.0005