Remove And Replace Procedures; Replacing The Lamp - PRG BAD Boy Field Service Manual

Remove and Replace Procedures

Replacing the Lamp

Parts:
71.2566.1200.0 1 EA LAMP, FASTFIT, PHILIPS MSR GOLD™
Tools and Supplies:
Cotton gloves or finger cots
WARNING: Remove power from luminaire before performing any maintenance procedures.
CAUTION: Refer to
To replace lamp:
Step 1. Remove power from lamp and allow lamp to cool for at least 5 minutes.
Step 2. Remove power from luminaire.
Step 3. At rear of luminaire, rotate backcap counter-clockwise to remove (it will still be connected
by a tether). Refer to
Step 4. Remove existing lamp by rotating lamp base counter-clockwise and pulling straight out of
backcap.
Step 5. Position new lamp as shown in
45 degrees clockwise to lock in place. You will hear a click when properly seated.
Step 6. Replace backcap.
Step 7. Reset Lamp Hours. Refer to the Bad Boy User Manual (02.9812.0001).
Step 8. Optimize lamp. (Refer to
0 2. 9 8 1 2. 0 0 05
M
AINTENANCE
"Proper Lamp Servicing and Operation"
Figure 3-11 on next page.
Figure 3-11
"Adjusting the Lamp"
: R R
EMOVE AND EPLACE
on page 24 before handling the lamp.
DETAIL A and insert into rear bulkhead. Rotate
on page 41.)
3
P
ROCEDURES
39