Replacing The Frost/Diffuser Paddle - PRG BAD Boy Field Service Manual

Replacing the Frost/Diffuser Paddle

Parts:
22.9812.0557
Tools and Supplies:
#2 Philips screwdriver
2mm Allen wrench
Spacer Tool (10.9812.0584)
WARNING: Remove power from luminaire before performing any maintenance procedures.
To replace the Frost/Diffuser Paddle Assembly:
Step 1. Remove power from luminaire and allow components to cool for at least 5 minutes.
Step 2. Remove R2/Designer Wheel Head Cover. (Refer to
page 26.)
Step 3. Disconnect Frost Sensor Cable.
Step 4. Rotate Frost/Diffuser Paddle Assembly to access set screw. Loosen set screw.
Step 5. Ensure paddle will clear Frost Sensor PCB (rotate if necessary), and remove Frost/Diffuser
Paddle Assembly.
0 2. 9 8 1 2. 0 0 05
1 EA ASSY, DIFFUSER PADDLE
Frost Sensor
Zoom Assembly
Frost/Diffuser
Set Screw
Paddle Assembly
Figure 3-21: Removing Frost/Diffuser Paddle Assembly
M : R
AINTENANCE EMOVE AND
"Removing the Head Covers"
R P
EPLACE ROCEDURES
on
3
51