Table of Contents
Advertisement
CHAPTER 6 | Navigating the Web-based Administration
The SMC8014WG-SI Gateway's management interface allows you to configure both basic and
advanced features and options. Some of these advanced functions include: hacker attack
detection, IP and MAC address filtering, intrusion detection, port forwarding setup, virtual DMZ
hosts, as well as other advanced functions.
Making Configuration Changes
Once a configuration change has been made on a page, be sure to click the [Apply] button at the
bottom of the page to enable the new setting.
SYSTEM
This section is used to configure the device mode and administration options including passwords
and idle timeout setting.
To access the System Settings configuration page, on the Side Navigation bar, click on [System]
link.
Password Settings
From this section you can configure new passwords for the [cusadmin] account.
You can also set the Idle Time Out value that the SMC8014WG-SI will keep an admin account
logged in for. The default Idle Time Out value is 10 min.
To access the Password Settings configuration page, on the Side Navigation bar, click on [System]
link and then click on the [Password Settings] link.
If your password is lost, or you cannot gain access to the user interface, press the Reset button on
the rear panel (holding it down for at least ten seconds) to restore the factory defaults.
LAN
From this section you can configure the following settings:
•
The PRIVATE LAN IP settings, including IP Address, Subnet Mask, and Domain Name.
- 14 -
Advertisement
Table of Contents
