Connecting To The Quickserver; Using The Toolbox Application To Discover And Connect To The Quickserver; Figure 16: Web Gui Landing Page - SMC Networks FieldServer QuickServer FS-QS-12 0 Series Startup Manual

6.3

Connecting to the QuickServer

6.3.1 Using the Toolbox application to discover and connect to the QuickServer


Install the Toolbox application from the USB drive or get it from the Sierra Monitor website:
www.sierramonitor.com/customer-care/resource-center?filters=software-downloads

Use the Toolbox application to find the QuickServer, and launch the Web GUI.
NOTE: If the connect button is greyed out, the QuickServer's IP Address must be set to be on the same
network as the PC. (Section 6.4)

Figure 16: Web GUI Landing Page

Page 20 of 46
QuickServer Start-Up Guide