Rear Panel Description - SMC Networks EZ Connect SMC8014WG-SI Install Manual

Rear Panel Description

Power
Item Description
Power Connect the included power adapter to this port.
CATV Connect your cable line to this port.
Reset Use this button to reset the power or restore the default factory settings.
ETH 10/100 Auto-sensing switch port (RJ-45). Connect devices on your local area
network to this port (such as a PC, hub, or switch).
Rebooting and Restoring the SMC8014WG-SI Gateway
The Reset button is located on the rear panel of the Gateway. Use a paper clip or a pencil tip to
push the Reset button.
Reboot
If the Gateway is having problems connecting to the Internet, simply hold down the reset button
for less than 2 seconds then release.
Restore Factory Defaults
If rebooting the Gateway does not resolve your issue, then you can follow these steps:
1. Leave power plugged into the Gateway.
2. Locate the reset button on the back panel, press and hold button for at least 10 seconds.
3. Release reset button. The Power, Status, and Ethernet LEDs will light up green, and the Cable
LED will blink amber while reconnecting to the network.
CATV Reset
Connector Button
- 7 -
LAN
Port