Table of Contents
Advertisement
configured port(s), it dynamically allows all incoming traffic from the server on any port for the
specified time.
To access the Special Application configuration page, on the Side Navigation bar, click on
[Firewall] link and then click on the [Special Application] link.
To enable this option, click the [Enable Triggering] checkbox.
To configure a Special Application Rule, follow the steps outlined below:
1. On the Side Navigation bar, click on [Firewall] then select [Special Application]
2. Click on the [Add] button on the Special Application page to access the [Trigger]
configuration section.
3. Enter in the [Name] that you want to use for this rule.
4. In the [Type] pull-down menu, select the data/traffic type that this rule will apply to.
The options are TCP | UDP.
5. Configure the [Port Number] that your application will be using as the outgoing trigger
ports.
6. Set the [Interval] of the rule. This is the time in between the outgoing and incoming data
traffic.
NOTE: If this value is set too low, the incoming ports will be closed before the return data
arrives at the firewall and the connection will be broken and the application will not work.
- 25 -
Advertisement
Table of Contents
