Insert Editing - JVC HR-S9600U Instructions Manual

58
EN

Insert Editing

Recorder
Audio/Video cable
(supplied)
Player
C.RESET
1
JOG
Your VCR
Audio/Video signal
Another VCR
1 2 3
2
4 5 6
7 8 9
0
4
CH
PAUSE
TIME SCAN
JOG/SHUTTLE
SHUTTLE
Insert editing replaces part of the recorded scene with new
material. Both the picture and Hi-Fi audio soundtrack are
replaced with new ones, while the normal audio soundtrack
remains unchanged. If you wish to change the normal audio
track as well, use the audio dubbing function simultaneously.
Use your VCR as the recorder.
Source tape
JOG
SHATTLE
Recorded tape
MAKE CONNECTIONS
1
Connect the player's VIDEO OUT or S-VIDEO OUT
and AUDIO OUT connectors to your VCR's VIDEO IN
or S-VIDEO IN and AUDIO IN on the front panel.
SET INPUT MODE
2
Press the NUMBER key "0" and CH so that "F-1"
appears in place of a channel number.
Be sure to select the correct FRONT AUX INPUT
("VIDEO" or "S-VIDEO"). (To select the correct AUX
INPUT, follow steps 4 – 6 from the "Edit From A
Camcorder" section
LOCATE END POINT
3
Load the recording cassette into your VCR, and play it
back to determine the edit-out point (the end of the
segment to be replaced) using the JOG/TIME SCAN
SHUTTLE controls or pressing TIME SCAN ™£
and PAUSE.
To use the JOG dial/SHUTTLE ring, first press the
JOG/SHUTTLE button on the remote control so that
the button lights up.
RESET THE COUNTER
4
Press C.RESET to change the counter display to
"0:00:00".
LOCATE START POINT
5
Determine the edit-in point (the beginning of the
segment to be replaced) using the JOG/TIME SCAN
SHUTTLE controls or pressing TIME SCAN ™£
and PAUSE.
Be sure to engage the Still mode at the edit-in point.
EDITING (cont.)
Before insert editing
After insert editing
pg. 54).
Normal audio
track
Video/Hi-Fi
audio track