Table of Contents
Advertisement
54
EN
Insert Editing
Recorder
Audio/Video cable
(supplied)
Player
C.RESET
Downloaded from:
https://www.usersmanualguide.com/
Your VCR
PAU SE
Audio/Video
signal
Another VCR
1
2
3
2
4
5
6
7
8
9
0
4
1
PAU SE
TIM E SCAN
Insert editing replaces part of the recorded scene with new
material. Both the picture and Hi-Fi audio soundtrack are
replaced with new ones, while the normal audio soundtrack
remains unchanged. If you with to change the normal audio
track as well, use the audio dubbing function simultaneously.
Use your VCR as the recorder.
Source tape
Before insert editing
Recorded tape
After insert editing
MAKE CO N N ECTIO N S
Connect the player's VIDEO OUT and AUDIO OUT
1
connectors to your VCR's VIDEO IN and AUDIO IN
connectors.
SET RECO RDER'S IN PUT MO DE
Set to "AUX". Press the N U M BER key " 0" and/or CH to
2
select depending on the connector being used – "L-1"
for the rear AUDIO/VIDEO IN connector, or "F-1" for
the front AUDIO/VIDEO IN connector.
LO CATE EN D PO IN T
Load the recording cassette into your VCR, and play it
3
back to determine the edit-out point (the end of the
segment to be replaced) using the JO G/ TIM E SCAN
SH U TTLE controls or TIM E SCAN
RESET THE CO UN TER
Press C.RESET to change the counter display to
4
"0
00
00".
:
:
LO CATE ST ART PO IN T
Determine the edit-in point (the beginning of the
5
segment to be replaced) using the JO G/ TIM E SCAN
SH U TTLE controls or TIM E SCAN
● Be sure to engage the Still mode at the edit-in point.
ED ITIN G (cont.)
Normal
audio track
Video/Hi-Fi
audio track
4¢ and
PAU SE .
4¢ and
PAU SE .
Advertisement
Table of Contents
