Insert Editing - JVC HR-S9400EE Instructions Manual

44
EN

Insert Editing

Set the REC SYSTEM switch to the appropriate position.
( pg. 27)
Recorder
• •
• • • •
• • • •
• • • •
• • • •
• • • •
Audio/Video signal
Player
C.RESET
PU SH JO G
Downloaded from: https://www.usersmanualguide.com/
Your recorder
TIME SCAN SHUTTLE
Another recorder
2
1 2 3
4 5 6
7 8 9
0
4
TV PRO G
PAU SE
Insert editing replaces part of the recorded scene with new
material. Both the picture and Hi-Fi audio soundtrack are
replaced with new ones, while the normal audio soundtrack
remains unchanged. If you wish to change the normal audio
track as well, use the audio dubbing function simultaneously.
Use your video recorder as the recorder.
Source tape
Recorded tape
8
MAKE CO N N ECTIO N S
1
Connect the player's VIDEO OUT and AUDIO OUT
connectors to your recorder's VIDEO IN and AUDIO IN
on the front panel.
SET IN PUT MO DE
2
Press N U M BER key "0" or TV PRO G so that "F-AU"
appears in place of a channel number.
● Refer to "To Select The External Input Mode" on page
39.
LO CATE EN D PO IN T
3
Load the recording cassette into your recorder, and play
it back to determine the edit-out point (the end of the
segment to be replaced) using the J O G/ TIM E SCAN
SH U TTLE controls or PU SH J O G
RESET THE CO UN TER
4
Press C.RESET to change the counter display to "0:00:00".
LO CATE ST ART PO IN T
5
Determine the edit-in point (the beginning of the
segment to be replaced) using the J O G/ TIM E SCAN
SH U TTLE controls or PU SH J O G
● Be sure to engage the Still mode at the edit-in point.
ED ITIN G (cont.)
Before insert editing
After insert editing
Video/Hi-Fi
audio track
and PAU SE .
and PAU SE .
Normal audio
track