Information On J Terminal; J Terminal (Jlip(Joint Level Interface Protocol) Connector) - JVC HR-S9600U Instructions Manual

64
EN
J terminal
CABLE
BOX
S VIDEO
IN OUT
NUMBER
1
MENU
IN OUT
ANTENNA
R
AUDIO
REMOTE AV
VHF/UHF
PAUSE COMPULINK
L
(MONO) TV OUT
CH3
VIDEO CH4
Back of VCR
1 2 3
2
4 5 6
8 9
7
0
4
TIME SCAN
OK

INFORMATION ON J TERMINAL

J Terminal (JLIP(Joint Level
Interface Protocol) Connector)
The J Terminal is used to connect the VCR to a personal
computer or similar device to allow computerized control of the
VCR during editing and certain other operations.
For further details consult your nearest JVC dealer.
JOG
SHATTLE
U.S. customers can contact JVC directly toll free at 1-800-252-
5722.
JLIP ID Number
Your VCR has its own JLIP ID number. This ID number must be
unique when your VCR is connected to another device via its J
terminal. The ID Number is preset to "1" at the factory. You can
change this number to any number between "1" and "99".
If it is necessary to change the JLIP ID number perform the
following steps.
ACCESS MAIN MENU
SCREEN
IN
1
Press MENU.
ACCESS INITIAL SET
SCREEN
2
Move the highlight bar (arrow) to "INITIAL SET" by
pressing CH 5∞ or TIME SCAN %fi, then press OK or
TIME SCAN
ACCESS JLIP ID NO. SET
SCREEN
3
Move the highlight bar (arrow) to "JLIP ID NO. SET" by
pressing CH 5∞ or TIME SCAN %fi, then press OK or
TIME SCAN
SET JLIP ID NUMBER
4
Press NUMBER key to
enter the desired ID
number, then press OK.
RETURN TO NORMAL
SCREEN
5
Press MENU.
NOTE:
This VCR may not accept a command from your personal
computer such as:
Power ON/OFF while the VCR is in the Timer mode.
.
.
JLIP ID NO. SET
PRESS NUMBER KEY (O-9)
PRESS (MENU) TO END
1
THEN (OK)