Insert Editing - JVC HR-S9600EK Instructions Manual

44

Insert Editing

Recorder
S-Video signal
Player
1 3
2
2
0000
1
2
Downloaded from: https://www.usersmanualguide.com/
Your recorder
C.RESET/ CAN CEL
Audio/Video signal
Another recorder
1 2 3
4 5 6
7 8 9
3
4
0
4
3
TV PRO G
PAU SE
AD VAN CED O PERATIO N S (cont.)
Insert editing replaces part of the recorded scene with new
material. Both the picture and Hi-Fi audio soundtrack are
replaced with new ones, while the normal audio soundtrack
remains unchanged. If you wish to change the normal audio
track as well, use the audio dubbing function simultaneously.
Use your video recorder as the recorder.
Source tape
Recorded tape
MAKE CO N N ECTIO N S
1
Connect the player's VIDEO OUT or S-VIDEO OUT
and AUDIO OUT connectors to your recorder's VIDEO
or S-VIDEO and AUDIO input connectors on the front
panel.
SET IN PUT MO DE
2
Press N U M BER key "0" and/or TV PRO G so that "F-1"
for the VIDEO/AUDIO input connectors or "S-1" for
S-VIDEO/AUDIO input connectors appears in place of
a channel number.
8
LO CATE EN D PO IN T
3
Load the recording cassette into your recorder, and play
it back to determine the edit-out point (the end of the
segment to be replaced) using the SH U TTLE ring or the
JO G dial or pressing
RESET THE CO UN TER
4
Press C.RESET/ CAN CEL (or 0000 ) to change the
counter display to "0:00:00".
LO CATE ST ART PO IN T
5
Determine the edit-in point (the beginning of the
segment to be replaced) using the SH U TTLE ring or the
JO G dial or pressing
● Be sure to engage the Still mode at the edit-in point.
Before insert editing
After insert editing
Video/Hi-Fi
audio track
and PAU SE .
@ #
and PAU SE .
@ #
Normal audio
track