Edit To Or From Another Vcr - JVC HR-S9600U Instructions Manual

56
EN
Edit To Or
From Another
VCR
AUDIO OUT
Player
CABLE
BOX
S VIDEO
IN OUT
S VIDEO OUT
S-Video cable
(supplied)
S VIDEO IN
VIDEO IN
Recorder
Advantages Of S-VHS Editing
S-VHS allows you make high resolution video recordings
when dubbing from one VCR to another.
You can edit from VHS to S-VHS, from S-VHS to VHS, or
from S-VHS to S-VHS.
From VHS to S-VHS: Record VHS playback signals in the S-
VHS mode. Although the picture quality is inherently
limited by the orignal VHS source material, the edited tape
has better picture quality than those made by VHS-to-VHS
editing.
From S-VHS to VHS: Because the picture quality of the
source material is very high, the edited tape has better
picture quality than those made by VHS-to-VHS editing.
From S-VHS to S-VHS: A high resolution copy is made of
a high resolution original S-VHS tape with minimal
picture degradation. This is the preferred method of
video dubbing.
Your VCR
IN OUT
ANTENNA IN
R
AUDIO
AV
REMOTE
VHF/UHF
PAUSE COMPULINK
L
TV OUT
(MONO)
CH3
VIDEO
CH4
VIDEO
OUT
Audio/Video cable
(supplied)
AUDIO IN
Another VCR
You can use your VCR as the player or the recorder.
MAKE CONNECTIONS
1
Connect an AV cable between the player's VIDEO OUT
and AUDIO OUT connectors and the recorder's VIDEO
IN and AUDIO IN connectors.
If using another VCR with an S-VIDEO input or
output connector, it is recommended to use the S-
VIDEO connection to minimize picture degradation
while editing.
When using your VCR as the recorder and a monaural
VCR as the player, connect the player's AUDIO OUT
connector to the AUDIO IN L connector on the recorder.
LOAD CASSETTES
2
Insert the playback cassette into the player and the
cassette to be recorded on into the recorder.
SET RECORDER'S INPUT
MODE
3
Set to "AUX". With this VCR, press the NUMBER key "0"
and/or CH to select depending on the connector being
used – "L-1" for the rear AUDIO/VIDEO IN connector,
or "F-1" for the front AUDIO/VIDEO IN connector.
NOTE:
If you use your VCR as the recorder and have connected
another VCR to your VCR's S-VIDEO IN connector, you
need to set "REAR AUX INPUT" to "S-VIDEO" at the
Function screen. Follow steps 4 – 6 from the "Edit From
A Camcorder" section (
SELECT "EDIT" FOR PIC-
TURE CONTROL SET MODE
4
Follow the "Picture Control" section on page 28, then
select "EDIT."
NOTE:
When you select "EDIT" to dub tapes, be sure to select
"AUTO" or ("NORM" when "VIDEO CALIBRATION" is
set to "OFF") after you finish dubbing the tapes.
START PLAYER
5
Set to its play mode.
NOTE:
If the player is equipped with a superimpose/OSD
disable feature then set "SUPERIMPOSE" to "OFF"
before pressing PLAY (
START RECORDER
6
Set to its record mode.
NOTE:
If you use an auxiliary input to connect a cable box or DBS
receiver, make sure that the correct AUX INPUT ("VIDEO" or "S-
VIDEO") is selected after you have finished editing (
6, page 54).
EDITING (cont.)
pg. 54).
pg. 23).
steps 4 –