Installing Your New Recorder; Basic Connections - JVC HR-S9400EE Instructions Manual

4
EN
Ba sic Connections
Aerial connector
21-pin AV input connector (SCART)
It's essential that your video recorder be properly connected.
Follow these steps carefully. THESE STEPS MUST BE COMPLETED
BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.
CHECK CO N TEN TS
1
Make sure the package contains all of the accessories
listed in " Specifications" (
SITUATE RECO RDER
2
Place the recorder on a stable, flat surface.
CONNECT RECORDER TO TV
3
The connection method you use depends on the type of
TV you have.
RF CO N N ECTIO N
● To Connect To A TV With NO 21-pin AV input
connector (SCART) . . .
a– Disconnect the TV aerial cable from the TV.
b– Connect the TV aerial cable to the ANT. IN jack
on the rear panel of the recorder.
c– Connect the provided RF cable between the RF
OUT jack on the rear panel of the recorder and the
TV's aerial connector.
Before operating the recorder, make sure the TV's
channel is set to the VID EO channel (
AV CO N N ECTIO N
● To Connect To A TV with 21-pin AV input connector
(SCART) . . .
a– Connect the aerial, recorder and TV as per " RF
CONNECTION" .
b– Connect an optional SCART cable between the AV1
IN/OUT connector on the rear panel of the recorder
and the TV's 21-pin AV input connector (SCART).
c– Choose the appropriate AV1 output signal (
OUTPUT SIGNAL SELECTION" on page 5).
S-VID EO CO N N ECTIO N
● If you have a TV with S-VIDEO input connector, see
"S-VIDEO Connection" on page 6.
Downloaded from: https://www.usersmanualguide.com/
IN STALLIN G YO U R N EW RECO RD ER
Back of TV
pg. 63).
pg. 10).
"AV1
21-pin SCART Cable (not provided)
Mains outlet
CO N N ECT RECO RDER TO
MAIN S
4
Plug the end of the mains power cord into a mains
outlet.
After you plug the mains power cord into a mains outlet, the
Auto Set Up display appears on the TV screen and/or on the
recorder's front display panel when the
recorder/remote control is pressed for the first time to power
on the recorder pg. 8.
RF Cable (provided)
Mains Power
Cord
button on the