Denso BTH-300BW User Manual page 82

Setting the communications parameters for the direct-connect interface
(1) Communications parameters setting screen
On the SET COMMUNICATION menu, select "2: CONNECTOR" to
call up the screen shown at left.
[1] PARAMETER: Switches to the communications parameters
setting screen.
[2] PROTOCOL: Switches to the communications protocol screen.
Select a desired screen by using the numerical keys or F5 and F6
keys, and then press the ENT key.
To return to the SET COMMUNICATION menu, press the C key.
On the SET CONNECTOR screen, select "1: PARAMETER" to call
up the screen shown at left.
Highlighted is the current setting.
[1] TRANSMIT SPEED: Sets the transmission speed.
[2] PARITY BIT:
[3] DATA:
[4] STOP:
Select a desired item by using the numerical keys or F5 and F6 keys.
Then select a desired setting by using the F7 and F8 keys.
To return to the SET CONNECTOR screen, press the C key.
Selecting the BHT-Ir protocol ignores the vertical parity,
character length, and stop bit length settings.
Selecting YMODEM requires the vertical parity, character
length, and stop bit length to be set to N, 8, 1, respectively.
67
Chapter 2 Getting Started the BHT and System Mode
Sets the vertical parity: none, odd, or even.
Sets the character length.
Sets the stop bit length.