Rotax 912 ULS 3 Operator's Manual page 12

1.3) Safety
General note
Revision
Measuring units
Translation
Symbols used
Effectivity: 912 Serie
OM Edition 2 / Rev. 0
Although the reading of such information does not eliminate the
hazard, understanding the information will promote its correct use.
Always use common workshop safety practice.
The information and components-/system descriptions contained
in this Manual are correct at the time of publication.
BRP-Powertrain, however, maintains a policy of continuous im-
provement of its products without imposing upon itself any obliga-
tion to install them on its products previously manufactured.
BRP-Powertrain reserves the right at any time, and without incur-
ring obligation, to remove, replace or discontinue any design, spe-
cification, feature or otherwise.
Specifications are given in the SI metric system with the USA
equivalent in parenthesis. Where precise accuracy is not required,
some conversions are rounded off for easier use.
This document has been translated from German language and
the original German text shall be deemed authoritative.
This Manual uses the following symbols to emphasize particular
information. This information is important and must be observed.
WARNING WARNU
CAUTION
WARNUN
NOTICE
WARNUNG
NOTES: Indicates supplementary information which
may be needed to fully complete or under-
stand an instruction.
A revision bar outside of the page margin in-
dicates a change to text or graphic.
BRP-Powertrain
Identifies an instruction which, if not fol-
lowed, may cause serious injury including
the possibility of death.
Identifies an instruction which, if not fol-
lowed, may cause minor or moderate inju-
ry.
Denotes an instruction which, if not fol-
lowed, may severely damage the engine
or other component.
page 1-4
April 01/2010