Usb Virtual Com Via 3656; Activate Usb Virtual Com; Inter-Function Delay - CipherLab 1564 User Manual

1564 Barcode Scanner

2.7 USB VIRTUAL COM VIA 3656

Use the USB cable to connect the scanner via 3656 to the USB port of PC and connect
the power supply cord if necessary. You may run HyperTerminal.exe on your computer,
and the scanned data will be transmitted to the computer.
Note: If you are using USB Virtual COM for the first time, you must install its driver from
the CD-ROM. Driver version 5.3 or later is required. Please remove older versions!

2.7.1 ACTIVATE USB VIRTUAL COM

2.7.2 INTER-FUNCTION DELAY

By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254
in units of millisecond, to match the computer response time of the keyboard interface.
Such delay time is inserted between every function code (0x01 ~ 0x1F) being
transmitted. The longer the delay time is, the slower the transmission speed will be.
1) Read the barcode above to specify the inter-function delay.
2) Read the "Decimal
(millisecond).
3) Read the "Validate" barcode on the same page to complete this setting.
92
User Guide
Value" barcode on page 251 for the desired inter-function delay
Activate 3656
USB Virtual COM
Inter-Function
Delay... (*0~254)
Enter Setup