Read A Setup Barcode; Configure Parameters - CipherLab 1564 User Manual

READ A SETUP BARCODE

CONFIGURE PARAMETERS

For most of the scanner parameters, only one read is required to set them to new values.
The scanner will respond with two beeps (low-high tone) when each parameter is set
successfully.
But for a number of special parameters, multiple reads are required to complete the
setting. In this case, the scanner will respond with a short beep to indicate it needs to
read more setup barcodes. These special parameters may require reading one or more
setup barcodes, such as
Numeric barcodes, say, for keyboard type, inter-character delay, length qualification
Hexadecimal barcodes, say, for character strings as prefix, suffix, etc.
When "BT HID", "USB HID" or "Keyboard Wedge" is configured for interface, Key
Type and Key Status will then become applicable. You may decide whether or not to
change key status when "Normal Key" is selected for Key Type.
To complete the configuration of these special parameters, it requires reading the
"Validate" barcode, and the scanner will respond with two beeps (low-high tone) to
indicate the input values are validated.
Update
Quick Start
15