Table of Contents
Advertisement
The example below shows how to set numeric parameters:
Steps
Action
1
Power on the scanner...
2
Enter the Configuration Mode...
3
Read a Setup barcode...
For example,
Normal setup
barcode
Normal setup
barcode
Special setup
barcode
Decimal barcodes
4
Exit the Configuration Mode...
5
The scanner will automatically restart itself...
OR
User Feedback if Successful
The scanner will respond with a long beep
(high tone) and its LED indicator will
become solid red and go off quickly.
The scanner will respond with six beeps
(high-low tone repeats three times), and
its LED indicator will become flashing red.
The scanner will respond with two beeps
(low-high tone) if reading a normal setup
barcode.
The scanner will respond with one short
beep if reading a special setup barcode
such as "Max. Length", indicating the
setup requires reading more barcodes.
Read the "Decimal Value" barcode(s).
Refer
to
Appendix
System"
The scanner will respond with two beeps
(low-high tone) when the input values are
validated.
Same as for Enter the Configuration Mode.
Same as for Power on the scanner.
Update
Quick Start
IV
"Decimal
17
Hide quick links:
Advertisement
Table of Contents
